Step 2  -   Glue-up

	Now we're truckin' It was body glue-up yesterday for #030. After a couple fresh passes through the jointer to resurface and square the edges, the two side were ready to glue. Tools needed: 4 heavy duty bar clamps, Titebond glue, wax paper and a damp cloth for wiping off glue squeeze out.
	A nice even coat of glue is applied to each edge and allowed to sit for a couple minutes. Since the glue contains a lot of water which will rust the bar clamps at the seam, a couple sheets of wax paper is placed over the bars to prevent rust stains from transfering into the body spread.
	And lastly the two sides are aligned and clamped for drying.